Probe Connection - Apex BiPPEX Pro Instructions D'utilisation

Oxymètre portable
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

English
5. Operation
5.1 Basic operation
Battery installation
Open up battery compartment cover with both hands evenly and carefully and
then install four "AA" Alkaline batteries according to the (+/-) polarity.

Probe connection

Solaris S100A or compatible probe is used (please check the pin lineup carefully
for installation).
Warning: It may damage the efficiency of the device if not apply with a
Solaris or Solaris compatible probe.
Plug the probe into the connection on the top of the device carefully (Fig. 5-1). If
extension cord is needed, please use Solaris cord AC031-113 or compatible cord.
Fig. 5-1
Warning: The function of the device could be compromised with the use of
extension cord other than Solaris AC031-113 or compatible cord.
Power On
• Press the "power switch" key
• The beep sound will last for 2 seconds to signal the power on of the device.
• All icons appear on the LCD screen and with backlight lasts for 60 seconds.
• The device is then in the "self-test" mode with the software version shown.
• The measurement starts at the completion of the "self-test."
• The device is with a default of time setup mode (please refer to 5.3 for time
setup).
for 1 second to activate the device.
4

Publicité

Table des Matières
loading

Table des Matières