Appendix; Troubleshooting; Polyphony - Korg SP-200 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Troubleshooting

If during use any of the following problems should occur, carefully examine the
instrument to see if you can find out what the problem is, and try resolving it by fol-
lowing the suggestions below. If the instrument will still not function properly refer
to your dealer or to an Authorized Korg Service Center.
Problem
The instrument
will not turn on.
No sound.

Polyphony

The SP-200 contains sampled sounds, which have been recorded, analyzed and pro-
cessed from the actual sounds of the original musical instruments. These sounds
usually consist of one or more different samples reproduced by pressing a key.
Sounds made of just one samples have a full polyphony of max. 60 voices, while
sounds made of two samples have a limited polyphony of max. 30 notes. Therefore,
when the number of sounding notes exceeds the limits, the sound will become dis-
continued.
Furthermore, when playing in Layer mode with more than two notes, the max.
polyphony depends on how many samples are used in total. Using the REVERB,
CHORUS further reduces the polyphony, respectively, by 10 and 3 notes.
30
CHAPTER

Appendix

Possible remedy
Check that the AC adapter is correctly connected to the piano and
the outlet.
(1) Make sure that the volume is not set on 0. If it is, bring it up to
an adequate level.
(2) Make sure that the MIDI Local function is not set on OFF. If it
is, set it to ON (or turn the instrument off and then on again).
6
Page
9
11
24
Chapter 6

Publicité

Table des Matières
loading

Table des Matières