GEZE TS 5000 R-ISM BG Mode D'emploi page 17

TS 5000 R-ISM BG
6.6 Connecting cable from power pack and cable from smoke detector
Place 24 V output cable from power pack on moving leaf into the inside of the smoke switch housing (6.).
X
Red ='+'
White = '–' .
Route 24 V cable of electrical hold-open device to supply terminal(1.).
X
Connect cable (2.).
X
Protect both 24V cables with foam lining against falling off (3.).
X
6.7 Connecting wire cable to trigger
Unscrew set screw and lock nut 12 mm at clamping part. (1.).
X
Suspend ball on wire cable in trigger lever (2.).
X
Lay wire cable in bottom guide of smoke detector housing (3.).
X
Guide wire cable into funnel
X
Thread clamping part onto wire cable (5.).
X
Insert clamping part and thread wire cable through oblong hole (6.).
X
Push wire cable redirection onto wire cable (7.).
X
(Fig. 6.7.2)
Loosen clamping screw
X
Thread wire cable with wire cable redirection into oblong hole (2.).
X
Thread past the clamping screw and guide out the oblong hole (3.).
X
Tension wire cable firmly and tighten clamping screw (4.).
X
Mount trigger lever (5.).
X
(4.).
(1.).
Mounting and securing
Fig.: 6.6.1
Fig.: 6.6.2
Fig.: 6.7.1
GB 6