Disposal And Recycling; Troubleshooting - Scheppach HC60 Traduction Des Instructions D'origine

10.8 Service information
Please note that the following parts of this product
are subject to normal or natural wear and that the fol-
lowing parts are therefore also required for use as
consumables.
Wear parts*: Cylinders, pistons, piston rings
* Not necessarily included in the scope of delivery!

11. Disposal and recycling

The equipment is supplied in packaging to prevent it
from being damaged in transit. The raw materials in
this packaging can be reused or recycled. The equip-
ment and its accessories are made of various types
of material, such as metal and plastic. Defective com-
ponents must be disposed of as special waste. Ask
your dealer or your local council.
Old devices must not be disposed of with house-
hold waste!
This symbol indicates that this product must not
be disposed of together with domestic waste in
compliance with the Directive (2012/19/EU)
pertaining to waste electrical and electronic
equipment (WEEE). This product must be disposed of
at a designated collection point.

12. Troubleshooting

Fault Possible cause
No supply voltage.
Insufficient supply voltage.
The compressor does
not start.
Outside temperature is too low.
Motor is overheated.
The non-return valve leaks.
The compressor starts
The seals are damaged.
but there is no pres-
sure.
The drain plug for condensation
water (14) leaks.
The hose connections have a leak.
The compressor
starts, pressure is
shown on the pressure A quick-lock coupling has a leak.
gauge, but the tools
do not start.
Insufficient pressure set on the pres-
sure regulator (3).
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
This can occur, for example, by handing it in at an
authorised collecting point for the recycling of waste
electrical and electronic equipment. Improper handling
of waste equipment may have negative consequences
for the environment and human health due to poten-
tially hazardous substances that are often contained
in electrical and electronic equipment. By properly
disposing of this product, you are also contributing to
the effective use of natural resources. You can obtain
information on collection points for waste equipment
from your municipal administration, public waste dis-
posal authority, an authorised body for the disposal
of waste electrical and electronic equipment or your
waste disposal company.
Remedy
Check the supply voltage, the power plug and the
socket-outlet.
Make sure that the extension cable is not too long.
Use an extension cable with large enough wires.
Never operate with an outside temperature of below
+5° C.
Allow the motor to cool down. If necessary, remedy
the cause of the overheating.
Have a service center replace the non-return valve.
Check the seals and have any damaged seals re-
placed by a service center.
Tighten the screw by hand. Check the seal on the
screw and replace if necessary.
Check the compressed air hose and tools and replace
if necessary.
Check the quick-lock coupling and replace if neces-
sary.
Increase the set pressure with the pressure regulator.
GB | 23