Installing The Printer On A Usb Port - Oki B710 Guide D'installation

You may be required to enter the IP address for the
printer. The IP address can be found on the MenuMap
(printed earlier).
Test the Printer Driver Installation
To make sure the printer driver is correctly installed,
print a page from any program. Reinstall the driver if
the installation failed.
Activate Optional Accessories
Note: If your printer has an optional paper tray or
Hard Disk Drive installed, you must enter the
driver and activate it.
1. Click Start > Settings > Printers (and Faxes) on
the Windows taskbar.
2. Right click the printer icon.
3. Click Properties.
4. Click the device Option tab.
5. Click [Get Information From Printer].
This will update installed device options and make
them available.
Set the Printer Configurations via a
Web Page
If you are working in a network environment, you can
use a web browser to display the printer or job printing
status and to change the settings.
Settings for the system and network ports can be
configured under [Printer], [Network] and
[Maintenance] on the web page.
> The web page facility is only available
when the printer is connected to the
network.
> Refer to the Network User's Guide if the
web page does not appear after carrying
out the steps 1 and 2 below.
1. Boot your computer, and start the web browser.
2. Enter the printer's IP address or URL in the
address input column on the web browser and
press the <Enter> key.
The IP value can be found on Page 1 of the printed
MenuMap under the heading "Network" (see
instructions for "Print a MenuMap" on page 10).
IP Address = ###.###.###.###
When entering this number into the address of the
browser you may omit leading zeros.
NOTE
Installing the Printer on a
USB Port
For the USB interface, install the driver before
installing the USB cable.
Install the Driver
1. Turn the printer OFF.
2. Insert the CD, in the CD-ROM drive. The CD will
autorun.
If it doesn't, click Start > Run > Browse. Browse to
your CD-ROM drive, double-click Setup. Click OK.
3. Select your language. Accept the license
agreement.
4. Click Install Driver.
5. Select local printer.
6. Follow the on-screen instructions.
7. When prompted, select printer emulation (PS or
PCL).
8. When prompted, connect the USB cable and switch
the printer ON.
Test the Printer Driver Installation
1. Click Start > Printers, and check to see if the
printer icon is present.
2. If not, reinstall the driver.
3. If the Printer icon is there, highlight the icon and
right click Properties, then click the Print Test Page
button.
A single test page should print.
If the test page does not print:
• Check to see if the printer displays "Ready to Print".
• Check for appropriate cable connections between
the printer and the PC or Network.
If Printer Displays "Ready to print" and the cable
connections are good, then reinstall the driver.
If this does not correct the problem, refer to the on-line
User Guide supplied on the CD which came with the
printer for further troubleshooting instructions.
11 / English
NOTE