Start-Up; Technical Data - Scheppach PM1800D Traduction Des Instructions D'origine

7. Start-up

Before you connect the equipment to the mains sup-
ply make sure that the data on the rating plate are
identical to the mains data.
Always pull the power plug before making adjust-
ments to the equipment.
Switching on/off
Do not use any device where the switch can not
be switched on and off. Damaged switches must
be repaired or replaced immediately by the cus-
tomer service.
Switching on (Fig.5)
• Operate the trip switch (5) at first. Press the ON/
OFF button (4) on the handle.
Start the machine at the lowest rotational speed
(Level 1).
Switching off
• Release the ON/OFF handle button.
This machine is not suited for continuous op-
eration.
Speed control (Fig. 6)
With this type, the motor's speed and thus the agita-
tor performance can be adjusted. (Level 1 - 6).
• You can continuously adjust the speed with the
speed control (6).
2- speed gear (Fig. 7)
The device is equipped with a 2-speed gear. If the
gear selection switch cannot be locked, turn the stir-
ring staff a little.
• For the speed selection turn the switch (7) by 180°.
1. speed: 0 min - 450 min
–1
2. speed: 0 min - 790 min
-1
Only operate this switch at standstill.
Working with the paint and mortar mixing tool
Before changing the mixing tool you must pull the
power plug.
Reduce the working speed when you immerse the
mixing tool into the material you want to mix and
when you take it out again. When the mixing tool is
fully immersed, raise the speed to maximum in order
to ensure adequate cooling of the motor. Move the
mixing tool through the mixing container during the
mixing operation. Continue mixing until all the mate-
rial has been thoroughly processed. When you are
finished with your mixing work, clean the mixing tool.
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
–1
-1

8. Technical data

Mains voltage
Power input
Idling speed 0-450 min
Protection class
Weight
Sound and vibration
Sound and vibration values were measured in ac-
cordance with EN 60745.
Sound pressure level L
pA
Uncertainty K
pA
Sound power level L
WA
Uncertainty K
WA
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Total vibration values (vector sum of three directions)
determined in accordance with EN 60745.
Vibration emission value a
h
K uncertainty = 1,5 m/s
2
Additional information for electric power tools
Warning!
The specified vibration value was established in ac-
cordance with a standardized testing method. It may
change according to how the electric equipment is
used and may exceed the specified value in excep-
tional circumstances.
The specified vibration value can be used to com-
pare the equipment with other electric power tools.
The specified vibration value can be used for initial
assessment of a harmful effect.
Keep the noise emissions and vibrations to a
minimum.
• Only use appliances which are in perfect work-
ing order.
• Service and clean the appliance regularly.
• Adapt your working style to suit the appliance.
• Do not overload the appliance.
• Have the appliance serviced whenever necessary.
• Switch the appliance off when it is not in use.
• Wear protective gloves.
230 V~, 50 Hz
1800 W
/ 0-790 min
-1 -1
II
7.2 kg
90 dB(A)
3 dB(A)
101 dB(A)
3 dB(A)
= 2,90 m/s
2
GB | 19