Mixer Section; Front Panel; Effect Section - Pioneer DDJ-SR Guide De Démarrage Rapide

Mixer section

1
a
2
b
c
3
4
6
7
5
9
8
1 TRIM control
2 EQ (HI, MID, LOW) controls
3 FILTER control
4 Headphones CUE/TAP button
5 Channel fader
6 Level indicator switch
7 Level indicator
8 Crossfader
9 CROSS FADER REVERSE indicator
a MASTER LEVEL control
b HEADPHONES MIX control
c SAMPLER VOLUME control

Effect section

This section is used to control the two effect units (FX1 and FX2).
Controls and buttons to operate the FX1 unit are located on the left side
of the controller, those to operate the FX2 unit are located on the right
side of the controller.
1 2 3
1 FX ASSIGN 1 buttons
2 FX ASSIGN 2 buttons
3 Effect parameter 1 control
4 Effect parameter 2 control
5 Effect parameter 3 control
6 FX BEATS control
7 Effect parameter 1 button
8 Effect parameter 2 button
9 Effect parameter 3 button
a TAP (FX MODE) button
1
2
3
4
5
4 5 6
7 8 9 a

Front panel

1 2 3
1 HEADPHONES LEVEL control
2 CROSS FADER REVERSE switch
3 CROSS FADER CURVE control
4 MIC LEVEL control
Rear panel
1 2 3
1 AUX IN LEVEL control
2 BOOTH LEVEL control
3 BOOTH/MASTER selector switch
4 ON/OFF switch
About the controls' setting values
The setting values of the controls, etc., below are controlled individually
for the respective decks in the Serato DJ software.
TRIM control
EQ (HI, MID, LOW) controls
FILTER control
Channel fader
TEMPO slider
If the values controlled by Serato DJ when the decks are switched differ
from the positions of this unit's controls, faders, etc., the controls, fad-
ers, etc., must be moved to the positions corresponding to the values
controlled by Serato DJ before they will operate.
The default values for decks 3 and 4 in Serato DJ are the center
position for the [TRIM] controls, [EQ (HI, MID and LOW)] controls
and [FILTER] controls, ±0.0% for [TEMPO] sliders, and the frontmost
position for the channel faders.
4
4
13
En