Stanley SB25PT-05 Manuel D'instructions page 17

O RIGINAL INSTRU CT I ON
4.3.3 CHARGER OPERATION
Refer to the indicators for the charge status of the battery pack.
DCB107, DCB112, DCB113, DCB115, DCB118, DCB132
Charging
Fully Charged
Hot/cold Pack Delay*
* DCB107, DCB112, DCB113, DCB115, DCB118, DCB132:
The red light will continue to blink, but a yellow indicator light will be illuminated during this
operation. Once the battery pack has reached an appropriate temperature, the yellow light will
turn off and the charger will resume the charging procedure.
This charger will not charge a faulty battery pack. The charger will indicate faulty battery by refusing to
light or by displaying problem pack or charger blink pattern.
NOTE: This could also mean a problem with a charger.
If the charger indicates a problem, take the charger and battery pack to be tested at an authorized service
center.
HOT/COLD PACK DELAY
When the charger detects a battery that is too hot or too cold, it automatically starts a hot/cold pack
delay, suspending charging until the battery has reached an appropriate temperature. The charger then
automatically switches to the pack charging mode. This feature ensures maximum battery life.
A cold battery pack will charge at about half the rate of a warm battery pack. The battery pack will charge
at that slower rate throughout the entire charging cycle and will not return to maximum charge rate even
if the battery warms.
4.3.4 ELECTRONIC PROTECTION SYSTEM
Li-Ion tools are designed with an Electronic Protection System that will protect the battery against
overloading, overheating or deep discharge. The tool will automatically turn off if the Electronic Protection
System engages. If this occurs, place the Li-Ion battery on the charger until it is fully charged.
4.3.5 WALL MOUNTING
DCB107, DCB112, DCB113, DCB115, DCB118, DCB132
These chargers are designed to be wall mountable or to sit upright on a table or work surface. If wall
mounting, locate the charger within reach of an electrical outlet, and away from a corner or other
obstruction which may impede air fl ow. Use the back of the charger as a template for the location of the
mounting screws on the wall. Mount the charger securely using drywall screws (purchased separately) at
least 1" (25.4 mm) long, with a screw head diameter of 0.28–0.35" (7–9 mm), screwed into wood to an
optimal depth leaving approximately 7/32" (5.5 mm) of the screw exposed. Align the slots on the back of
the charger with the exposed screws and fully engage them in the slots.
4.3.6 CHARGER CLEANING INSTRUCTIONS
WARNING: Shock hazard. Disconnect the charger from the AC outlet before cleaning. Dirt and
grease may be removed from the exterior of the charger using a cloth or soft non-metallic brush.
Do not use water or any cleaning solutions.
18