Safety Notes; Important Notes; Functions - LGB 99 201 Serie Mode D'emploi

Safety Notes

• This model may only be used with the operating system designed for it.
• Use only switched mode power supply units and transformers that are designed
for your local power system.
• This locomotive must never be supplied with power from more than one power
pack.
• Pay close attention to the safety notes in the instructions for your operating sys-
tem.
• Not for children under the age of 15.
• WARNING! Sharp edges and points required for operation.

Important Notes

• The operating instructions are a component part of the product and must therefore
be kept in a safe place as well as included with the product, if the latter is given to
someone else.
• Please see your authorized LGB dealer for repairs or spare parts.
• Disposing: www.maerklin.com/en/imprint.html

Functions

• This model is designed for operation on LGB two-rail DC systems with conventio-
nal LGB DC train controllers or power packs (DC, 0 - 24 volts).
• Interface for installation of DCC.
Note: Use a locomotive controller with more than 1 amp of train current for this
model.
Mode of Operation Switch
This model has a four-position switch for the mode of operation. It is located in the
engineer's cab (Figures 1 & 2).
Pos. 0 Locomotive stored on a siding without current
Pos. 1 Lighting and smoke unit turned on
Pos. 2 Locomotive motor, smoke unit, and lighting turned on
Pos. 3 Same as Position 2
Smoke Unit
This model is equipped with a smoke unit. Fill the smoke stack only halfway with
smoke fluid. If you put in too much fluid, the smoke unit cannot produce smoke.
Important! Use only LGB smoke and cleaning fluid (item no. 50010). Other fluids can
damage your locomotive.
Important! Do not touch the heating element in the middle of the smoke unit. It is hot
and can break.
Note: The smoke unit can be operated "dry" without smoke fluid.
Multi-Purpose Socket
This model has a general-purpose socket on the back wall of tender for flat plugs
(Figure 3). If you are equipping a car with interior lighting or with a sound effects
module, you can connect it to the socket and power that circuit with track voltage. To
remove the cover of the socket, pull it straight out. If the cover is tight, gently use a
small straight screwdriver to pry it out (do not pull out the rectangular outer housing).
Multi-Train System
TThe model is equipped with a digital interface to connect a 3 amp DCC decoder.
Remove the plug on the decoder interface and connect the decoder.
We recommend to use MTS Decoder 55027, the plug of which directly fits into the
socket interface. We recommend to have the decoder mounted by the LGB factory
service station.
When a decoder is integrated in the locomotive, the power control switch ist obso-
lete.
6