Preparing The Paslode Cordless Framing Nailer For Use - Paslode CFN325XP Mode D'emploi

Preparing the Paslode Cordless Framing Nailer for Use

Unloading Fasteners
A. Pull the follower back to
the end (square pocket
area).
B. Press the button and the
follower will lock in place.
C. Flip the tool and nail strip
will drop out.
D. Pull the follower to the
very end of the guide, so the
button will pop out and the
follower will release from
that position.
Lockout Feature
The purpose of this feature is to prevent needless
blank cycling,which could waste fuel and damage
tool components. Five (5) nails will be left in the
magazine when the follower reaches the lockout
area. The indicator arrow shows that you can reload.
It does not indicate that the Cordless Framing Nailer
is empty. Because of a lockout feature in the
Cordless Framing Nailer it will not operate when the
nail supply in the tool is less than six (6) nails.
Paslode Cordless Framing Nailer and
Outdoor Weather
Use the Cordless Framing Nailer outdoors, in clear weather,
when the nailer, fuel cartridge, and battery are between
14°F (-10°C) and 120°F (49°C.
HOT WEATHER OPERATION
The Cordless Framing Nailer requires cooling of the motor
assembly to operate properly. The fan normally provides
the necessary air flow to permit continuous operation.
Whenever the Cordless Framing Nailer is idle for extended
periods, keep the Paslode Framing Fuel Cell and tool out of
direct sunlight and in surroundings where temperatures
will not exceed 120°F(49°C). After extended periods of
continuous use, it may be necessary to cool the motor by
setting tool aside for 10-15 minutes or until the tool
operates normally. An overheated tool may not drive nails
completely or may operate erratically.
COLD WEATHER OPERATION
Fuel at cold temperatures lose the required propellant force.
Bring the tool, battery, and fuel cartridge above minimum
operating temperature without direct exposure to flame, and
check the battery.
The Cordless Framing Nailer should not be used in the
rain or where excessive moisture is present. The use
of the Paslode Cordless Technology under these
conditions may result in damage to tool components
and cause tool to malfunction.
CAUTION
13