Paslode CFN325XP Mode D'emploi page 12

Paslode Framing Fuel Cell
Inserting Paslode
Framing Fuel Cell
A. To insert the Paslode
Framing Fuel Cell into the
Cordless Framing Nailer,
press up at the bottom of the
actuator cover and pivot
outward to open. The cover
will swing out of the way.
B. Lift the Paslode Framing
Fuel Cell adaptor and insert
the fuel cell into the tool.
C. Release the adaptor so it
is centered on the fuel cell.
D. Close the actuator cover
to complete the loading of
the fuel in the Cordless
Framing Nailer. Do this by
swinging it up and over the
Paslode Framing Fuel Cell,
and pushing down until the
actuator cover snaps into
position.
12
1. Press Up
2. Pull Out
1. Swing Up
2. Push Down
Fasteners
The Paslode Cordless Nailer drives Paslode RounDrive
and D/Head nails, which have been collated into strips.
The use of nails that do not meet Paslode standards could
cause tool damage and void your warranty. Paslode nail
sizes and types are illustrated in the Fasteners and Appli-
cations section.
Loading Fasteners
A. Drop the nail strip into the
empty magazine.
B. Pull the follower up past
the last nail.
C. Tool is ready to shoot.
®