Publicité
Les langues disponibles
Les langues disponibles
EnglisH
10
Trimming with the trimming comb (HP6572 only)
Use the sensitive area shaving head with the trimming comb attached to trim your bikini line to a
length of 3mm.
You can also use the trimming comb to pretrim long hairs (longer than 10mm) on the underarms
or bikini line.
1
Press the release button (1) and remove the epilating head from the epilator (2) (Fig. 10).
2
Put the sensitive area shaving head on the appliance and press it until it snaps home ('click').
3
Put the trimming comb on the sensitive area shaving head (Fig. 14).
4
Follow steps 3 to 6 in section 'Shaving the underarms and bikini line'.
Note: Make sure the surface of the trimming comb always stays fully in contact with the skin to ensure
an even trimming result.
5
When you have finished trimming, switch off the appliance and clean the sensitive area
shaving head and the trimming comb (see chapter 'Cleaning and maintenance').
6
Leave the trimming comb on the sensitive area shaving head when you store the appliance.
Overheat protection
The epilator has an integrated overheat protection, which prevents overheating of the appliance.
Note: To avoid overheating of the epilator, do not press the appliance too hard onto your skin. The epilator
works best when you move it over your skin without exerting any pressure.
1
If the overheat protection is activated, the appliance switches off automatically and the speed
setting indications flash red.
2
Let the appliance cool down.
The lights stop flashing after 30 seconds.
,
3
When the appliance has cooled down, you can switch it on again. If the lights start to flash
red again, the appliance has not yet cooled down completely.
Overload protection
If you press the epilating head too hard onto your skin or when the rotating tweezers of the
epilating head get blocked (e.g. by clothes etc.), the appliance stops and the speed setting indications
start to flash red for 5 seconds.
1
Check if the rotating tweezers of the epilating head are blocked by turning the tweezers with
your thumb until you can remove whatever is blocking the rotating tweezers.
2
Switch on the appliance again.
Do not press the appliance too hard onto the skin.
Cleaning and maintenance
Note: Make sure the appliance is switched off and unplugged before you start to clean it.
Never use scouring pads, abrasive cleaning agents or aggressive liquids such as petrol or acetone
to clean the appliance.
-
Clean the appliance after each use to ensure better performance.
-
Never rinse the appliance or the adapter under the tap (Fig. 15).
-
Keep the appliance and the adapter dry (Fig. 16).
4203.000.4532.1.indd 10
08-12-09 12:31
Publicité
