Laser Emission Data; Controls & Functions; Master/Slave Mode - Ibiza Light LZR200RGB-MULTI Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 5

LASER EMISSION DATA

As measured under IEC measurement conditions for classification.
Laser Classification
Red Laser Medium
Green Laser Medium
Blue Laser Medium
Beam Diameter
Pulse Data
Divergence (each
Divergence (total light)
Installation
The unit should be mounted via its screw holes on the bracket. Always ensure that the unit is firmly fixed to avoid
vibration and slipping while operating. Always ensure that the structure to which you are attaching the unit is secure
and able to support a weight of 10 times of the unit's weight. Also always use a safety cable that can hold 12 times
the weight of the unit when installing the fixture.
CONTROLS & FUNCTIONS
When the unit is powered on, the LED monitor on rear panel shows the current operating standalone mode or DMX
address of DMX mode. The LED control panel allows setting and changing the operating mode of the laser very easily.
After every reset or save, the new mode information will be shown on the LED monitor at next power on.
Mode/Function: Set the operating mode of laser.
Confirmation: Confirms all settings or changes of LED control panel.
UP/DOWN: Changes the operating mode, parameter or DMX address.
Stand Alone Preprogrammed Laser Show
 Press FUNC to enter MODE OPTION.
 Press UP or DOWN to select your favorite Stand Alone mode as above.
 Press ENTER to confirm the setting.
The laser is working in stand alone. Each time when you turn on your laser, you will
have this confirmed laser show.
In the MODE OPTION setting, the stand alone laser show that you are going to choose, is flashing. Press UP or DOWN
to change stand alone laser show, you will have 21 different stand alone preprogrammed laser show.

MASTER/SLAVE MODE

Press FUNC to enter MODE OPTION
Press the UP/DOWN buttons until the LED panel shows SLAV
Press ENTER to confirm the setting.
The laser is working in "SLAVE MODE". Connect MASTER laser and SLAVE lasers with DMX cable, the SLAVE lasers do
what exactly MASTER laser does.
©Copyright Lotronic 2017
Class 3B
LD GaAlAs 650nm, typical
DPSS Nd:YVO4, 532nm
LD GeAs 450nm, typical
<5mm at aperture
All pulses < 4Hz (>0.25sec)
<2 mrad
<90 degrees
LZR200RGB-MULTI
1
2
FUNC
UP
DOWN ENTER
3
3

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

15-1163n

Table des Matières