How To Use The S8 Compact; Set U P The S8 Compact; Assemble The Mask; Start Treatment - ResMed S8 Compact System Manuel Utilisateur

338249r1.book Page 8 Friday, June 10, 2005 3:22 PM
H U
OW TO
Please refer to the illustrations in section D of the illustration sheet.
S U S8 C
ET P THE
1
S8 C
Place the
CAUTION
!
Be careful not to place the device where it can be bumped or where someone is
likely to trip over the power cord.
Note: You can also place your S8 Compact on the floor beside or underneath your bed.
Ensure that the area is free from dust and clear of bedding, clothes, or any other objects
that could block the air inlet.
2
Connect the power cord to the socket at the rear of the flow generator (D-1). Plug
the other end of the power cord into the power outlet.
WARNING
!
Make sure the power cord and plug are in good condition and the equipment is not
damaged.
3
Connect one end of the air tubing firmly onto the air outlet (D-2).
WARNING
!
Only ResMed air tubing should be used with your flow generator. A different
•
type of air tubing may alter the pressure you actually receive, reducing the
effectiveness of your treatment.
Blocking the hose while in operation could lead to overheating of the device.
•
A M
SSEMBLE THE
1
Assemble your mask system according to the mask user instructions.
2
Connect your mask system to the free end of the air tubing (D-3).
The S8 C
OMPACT
S T
TART REATMENT
1
Make sure the power is on.
The product name is displayed briefly on the LCD screen, then the standby (Ramp)
screen appears. The key and LCD backlights also turn on.
2
Lie down and arrange the air tubing so that it is free to move if you turn in your sleep.
8
S8 C
SE THE OMPACT
OMPACT
on a table near the head of your bed.
OMPACT
ASK
is now ready for use (D-4).