Publicité
Les langues disponibles
Les langues disponibles
Out of memory
In total the memory can hold up to 59 messages
(including the outgoing message) or a maximum of 30
mins. When
flashes in handset or the base unit flashes
FF, no new messages can be recorded until the old ones
have been played back and deleted. In that case, the
answer machine responds with the outgoing message for
Answer Only.
PLEASE NOTE! Remember to delete messages regularly!
Remote Access
The unit can be remotely accessed using an ordinary tone
dialling telephone.
1. Call the answer machine.
2. Press
when the outgoing message is played.
*
3. Enter the PIN code, see Answer Machine Settings. One
beep confirms correct code.
4. Select a remote access command, see below.
5. Replace the handset.
Command
Function
2.......................Erase single msg during playback
4.......................Skip to previous message
5.......................Playback of messages
6.......................Skip to next message
7.......................Start the answer machine
8.......................Stop
9.......................Turn off the answer machine
Remote activation
The answer machine can be activated via the remote
access functions.
1. Call the answer machine. It will answer after
approximately 10 rings.
2. Press
when the outgoing message is played.
*
3. Enter the PIN code, see Answer Machine Settings. One
beep confirms correct code.
4. Press
.
7
5. Replace the handset.
English
Troubleshooting
Check that the telephone cord is undamaged and properly
plugged in. Disconnect any additional equipment,
extension cords and other phones. If the problem is
resolved, the fault is with some other equipment.
Test the equipment on a known working line (e.g. at a
neighbour's house). If the equipment works there the fault
is probably with your telephone line. Please report this to
your network operator.
No number shown when ringing
- This function requires a Caller ID subscription from
your service provider.
Warning tone during a call/Not possible to
make calls
- The batteries may be running low (charge the handset).
- The handset may be nearly out of range. Move closer to
a base unit.
Telephone does not work
- Check that the adapter/phone cord is connected
correctly.
- Check that you have selected Tone Dial, see System
Settings.
- Check the charge status of the handset batteries.
- Connect another functioning telephone to the network
wall socket.
The telephone continues to ring
- Some of the telephone's ringers do not follow the line
signal, which means that the signal may continue for
up to 8 seconds after answering a call.
The answer machine is not answering
- Memory may be full. Listen to/delete your messages.
- Check that the adapter/phone cord is connected
correctly.
- Check that the answer machine is switched on.
The answer machine does not respond to
remote access
- Check that you are using a tone dial telephone.
- Try holding the buttons down longer, approximately 1
second per digit.
If the telephone still does not work, contact the place of
purchase for service. Don't forget the receipt or a copy of
the invoice.
Publicité
