Publicité
Les langues disponibles
Les langues disponibles
Expanded system (+1)
The call number for internal calls will be shown in
the display in standby mode. The base unit should be
positioned centrally so that the coverage area is roughly
equal for all handsets.
Intercom
1. Press
.
I
2. When there are more than 2 handsets: Enter the call
number
-
for the handset you wish to call or press
1
6
to call all handsets.
9
3. Press Select.
A tone will be heard if an external call comes in while
an internal call is in progress. End the internal call by
pressing
and answer the external call with
L
Transferring calls/Conference between handsets
1. An external call is connected.
2. Press
.
I
3. When there are more than 2 handsets: Enter the call
number
-
for the handset you wish to call or press
1
6
to call all handsets.
9
4. Press Select.
5. To transfer: press
L
For conference: hold down
Answer Machine (only
NeoBio 45r)
When the answer machine is switched on
calls are answered after a set number of
rings, your outgoing message is heard and the caller can
leave a message. The total memory capacity is up to 30
mins. Most functions can be accessed from both base unit
and handset.
Switching the answer machine on/off
Press
(on the base unit) to switch the answer machine
1
on/off. If the base unit's display is flashing/showing
-- the answer machine is disconnected or time/date is
not set..
On/Off from the handset
1. Press Menu. Scroll to Answer Machine. Press Select.
2. Scroll to TAM On/Off. Press Ok.
3. Scroll to desired setting. Press Ok.
If the handset's display shows
answer machine is switched on.
,
.
I
with a steady light the
English
Outgoing message
The outgoing message (max 3 min) is heard by incoming
callers. There are two separate outgoing messages, one for
Answer Only (callers cannot leave a message) and one for
normal answer function.
1. Press Menu. Scroll to Answer Machine. Press
Select.
2. Scroll to TAM Settings. Press Select.
3. Scroll to OGM Settings. Press Select.
4. Scroll to Answer & Record/Answer Only. Press
Select.
5. Scroll to Record. Press Select.
6. After the long beep you can record your message
(speaking approx. 20 cm from the keypad). Press Ok.
.
7. The message will be played back to you. Repeat the
above to change.
Also select desired answer function. See Answer Machine
Settings.
Screening
Incoming messages will be heard on the loudspeaker of
the base unit as they are received. If nothing can be heard,
check that the volume is turned up and that the function
has been activated – see separate description. You can
also press Ok on the handset while a message is being
recorded.
The call can be intercepted by pressing
the receiver of another telephone.
Using the answer machine (base unit)
The numbers on the base unit will flash when there
are new messages.
Press
(base unit) to start playback.
9
Command
8 8
9 9
/
.........Prev msg/Skip forward.
■ ......................Stop playback.
X ......................Delete current message.
VOL + / - . .........To increase/decrease the volume.
Delete all old messages
After playback: Hold down X until you hear a beep.
Function
or by lifting
Publicité
