Publicité
Les langues disponibles
Les langues disponibles
Connection
1. Connect mains adapter/phone cable to wall sockets.
2. Insert batteries (1.2V NiMH) in accordance with the
markings.
3. Charge with the keypad facing outwards (24 hours the
first time).
4. Press Menu.
5. Scroll
/
to HS Settings.
{
}
6. Press Select (left menu button).
7. Scroll to Language. Press Select.
8. Scroll to desired setting. Press Select.
9. Press
or Back repeatedly for standby mode.
L
Battery
When the batteries are new and fully-charged (10 hours)
they will last for approx. 100 hours' standby time or
approx. 10 hours' call time. These times apply at normal
room temperature. Full battery capacity will not be
reached until the batteries have been charged 4-5 times.
It is not possible to overcharge or damage the batteries by
charging them for "too long".
If the batteries are completely discharged it can take up to
5 minutes' charging before the display lights up.
Battery LED
When the batteries are running low
warning tone will be heard during calls.
Handset indicator will continue to rotate as long as
handset is placed on the base and will not stop when fully
charged.
The indicator on the base will however start to flash when
battery is fully charged
Please note!
When the battery is low or when there is too great a distance
to the base unit the telephone will be unable to connect to
a line. Do not place the base unit close to other electrical
equipment, in direct sunlight or other strong heat sources!
This is to minimize the risk of any interference. It is normal
for the device to become warm during charging and this is not
dangerous. Use only original batteries. The guarantee does
not cover any damage caused by using the wrong batteries.
The equipment will not work during power cuts, so a corded
telephone ought to be used as a back up.
English
Base unit indicators
7
Only NeoBio 45r:
Range
The telephone's range depends on whether or not the
radio waves carrying the call are restricted by obstacles
in their path, and is usually between 50 and 300 metres.
Coverage can be improved by turning one's head so that
the handset is aligned with the base unit. Sound quality
declines as the limit is reached until the call is finally
interrupted. The
within range and flashes when it is out of range.
The bars beside the
Making a call
1. Enter the desired number. Delete if necessary with
2. Press
Please note!
will flash and a
To switch between speaker/handset, press
mode, you cannot both speak at once – you must take it in
turns to talk.
Receiving a call
1. Wait for the handset to ring.
2. Press
Audio Setup
The volume may be adjusted during a call with
Redial
Press
dialled numbers with
Mute button
The microphone can be switched on/off during a call
with Mute/Unmute.
Shines with a steady light during charging and
flashes when the battery is fully charged.
Shines with a steady light during calls and flashes
when there is an incoming call or new message on
the answer machine.
symbol is shown when the phone is
6
symbol indicate signal strength.
6
Clear.
to call. Press
L
to answer. Press
/
and scroll between the 20 most recently
r
}
/
{
}
to end.
. In speaker
/
to end.
L
/
{
}
. Press
.
.
Publicité
