Publicité
Les langues disponibles
Les langues disponibles
Electric pallet truck EGU PS 22 A
English
3.6.4 Entering lifts
The driver of an industrial truck may only use lifts with sufficient load-carrying capacity, which are de-
signed to accommodate such vehicles and for which permission has been granted by the operator. This
permission must be obtained before using the lift. Inside the lift, the vehicle must be positioned in such a
way that no part of it comes into contact with the shaft. Pedestrian-led vehicles may be driven into the lift
with load-carrying mechanisms. Accompanying persons should enter the lift after the vehicle and leave it
before.
3.6.5 Driving on loading ramps
Before driving onto loading platforms the driver must satisfy himself that they are properly attached and
secured and have sufficient load-carrying capacity. The vehicle is to be driven slowly and carefully.
3.7
Depositing of the Load
Stop just before the stacking area and lift the load in safe distance over the pile.
Manoeuvre the load directly above the pile and bring the tie bar in upper braking position.
Lower the load until fork arms are discharged.
Ensure safe reversing, lower the fork arms and move away.
4
Maintenance Instructions – View
Safety warning
Before inspection and maintenance work is carried out, appropriate measures should be taken to
remove all loads from the electric pallet truck.
Maintenance Intervals
daily or each time before
use
every 50 operating hours
or monthly
every 200 operating hours
or quarterly
every 500 operating hours
or every 6 months
every 1000 operating hours
or annually
if required, but at least eve-
ry 6 years
)
*
New units require the first oil change after max. 500 operating hours.
**)
e.g. by Pfaff-silberblau after-sales service
Die Lebensdauer des Flurfördergerätes ist begrenzt, verschlissene Teile müs-
sen rechtzeitig erneuert werden.
technische Änderungen vorbehalten
Maintenance Works
Check operating elements for faultless operation.
Check condition of the travelling rollers and roller axles
The guiding rollers are provided with long-term lubrication and are thus virtual-
ly maintenance-free.
Grease running paths and lateral faces of guide rollers in the lifting carriage.
Check the level of the hydraulic oil with forks completely lowered and the pallet
truck in horizontal position.
Check the hydraulic system for leakage, seating of unions and chafe marks
(hoses).
Check adjustment of the lifting chain, if necessary adjust, clean and grease
Check seating of all screw connections.
Lubricate conical lubrication nipple and turntable bearing.
Re-adjust battery pole screws, tightening torque approx. 2-3 Nm.
Check proper state and tight seat of all electric wires for control current and
main current
Check the carbon brushes of the electric motor for smooth running and wear.
Check the finger lever for spring pressure and perfect return movement.
Check seating and smooth running of the control handle.
Check all parts of the pallet truck for wear and replace defective parts where
necessary
Replace hydraulic oil and filter
)
Change gear oil. *
Check readability of type plate.
Check electric installation acc. to directive BGV A3
Authorise inspection by competent technical expert **
Replace hydraulic pressure hoses.
design changes under reserve
F 08.01.162
)
changements techniques sous réserve
23
Publicité
