Publicité
Les langues disponibles
Les langues disponibles
■
5
■
6
90°
4
2
3
1
■
7
3
■
8
■
9
■
■
1 0
1 1
10 s
4
GB
Installation
■
1
Flush the water supply pipes thoroughly.
Note: Prepare the stop valves and the flexible hoses.
■
2
Install the two water supply brackets into the wall.
Note: Use wall anchors (not included).
■
3
Connect the flexible hoses to the water supply brackets.
Note: Flexible hoses/copper tubes, nuts, packings, friction rings and cone washers are not included.
■
4
Connect the controller to the water supply brackets.
Leave the manual operating valve ( ) in the position shown in the illustration.
Only use this valve in a power outage or similar situation.
■
5
Fasten the spout.
■
6
Connect the hose to the controller.
● Cut the hose if necessary.
● Open the stop valves to check connections for water leakage.
■
7
Attach the handle to the bowl.
● Be sure to attach the handle before installing the bowl to the counter.
● Tighten the nut with your hand. Do not use pliers.
● Be careful not to let the cord become caught between them, when installing.
■
8
Connect the handle to the controller.
Secure the cord in a suitable position.
■
9
Attach the controller cover.
■
1 0
Connect the mains plug.
After connecting the mains plug, the handle lights pink for approx. 20 seconds while enabling its default
setting. Do not touch the handle until the light turns off.
■
1 1
Test operation.
Open the stop valves, and press the handle continuously for 10 seconds.
The water temperature adjusts automatically, and the water stops.
Test the handle within 10 minutes after connecting the mains plug.
5
14
Publicité
