Warning Messages Displayed On The Control Panel - MVP Jet-Tech 757E Instructions Pour L'installation, Emploi Et Entretien

2C – WARNING MESSAGES
DISPLAYED ON THE CONTROL
PANEL
(
Elettronic versions only
N.B.
If the machine is in OFF mode, warning
messages are not visualized on the
display. Turn ON the machine to visualize
type of error or breakdown.
The following warning
visualized on the display:
MODEL
MODEL NOT RECOGNIZED
The model present in memory does not
correspond to any of the models
expected (index of the corrupt model).
CHECKSUM
CHECK CORRUPT PARAMETERS
Memory parameters error or damaged board.
The electronic board
parameters and report errors.
EXT.EEPROM
MEMORY DEVICE IS DAMAGED
Turn off and restart the machine, if the
problem persist, the memory is damage
ZERO CROSSING
ELECTRONIC DEVICE IS DAMAGED
Turn off and restart the machine, if the
problem persist, the memory is damage
FILL
WATER FILL
Water fill not completed during the available
maximum time.
Verify the water supply
connected, opened and free of obstructions.
Verify the solenoid valve filter is free of
possible obstructions and deposit.
Verify the water supply pressure is adequate
(par.1D – Technical Data).
Verify the machine's door is completely
closed and the overflow device is correctly
positioned inside the tank.
DRAIN
DRAIN ANOMALY
Drainage not completed during the available
maximum time.
)
messages are
restores default
is correctly
Verify the overflow device is completely
removed and not obstructions are present
on the water drain line.
Verify the drain wires are correctly
connected to the electronic board.
BOILER PROBE
BOILER PROBE ANOMALY
Boiler temperature probe not connected or
faulty
Verify the probe is correctly and well
connected to the electronic board.
Verify the probe is correctly positioned
inside the tank and there is not presence of
limestone on it.
TANK PROBE
TANK PROBE ANOMALY
Tank temperature probe not connected or
faulty.
Verify the probe is correctly and well
connected to the electronic board.
Verify the probe is correctly positioned
inside the tank and there is not presence of
limestone on it.
RINSE PROBE
RINSE PROBE ANOMALY
Rinse temperature probe not connected or
faulty.
Verify the probe is correctly and well
connected to the electronic board.
Verify the probe is correctly positioned
inside the tank and there is not presence of
limestone on it.
FOLLOWING ACTIONS
MACHINE ERROR OR BREAKDOWN:
Booster and tank heating elements are
interrupted, water load is disactivated,
control panel display visualizes the error
and the electronic card is inactivated. All
led buttons are OFF. Washing cycle is
interupted (stanby mode) and restored if
the problem is solved. It is always possible
to turn OFF the machine by pressing button
"A" ON/OFF, and if the problem is solved,
warning messages are not more displayed.
AFTER
8