Warning Messages Displayed On The Control Panel - MVP Jet-Tech 757E Instructions Pour L'installation, Emploi Et Entretien

3D – WARNING MESSAGES
DISPLAYED ON THE CONTROL
PANEL
(
Elettronic versions only
N.B.
If the machine is in OFF mode, warning
messages are not visualized on the display.
Turn ON the machine to visualize type of
error or breakdown.
The following warning
visualized on the display:
MODEL
MODEL NOT RECOGNIZED
The model present in memory does not
correspond to any of the models
expected (index of the corrupt model).
CALL TECHNICAL SERVICE ASSISTANCE
CHECKSUM
CHECK CORRUPT PARAMETERS
Memory parameters error or damaged board.
The electronic board
parameters and report errors.
CALL TECHNICAL SERVICE ASSISTANCE
EXT.EEPROM
THE MEMORY DEVICE IS DAMAGED
Turn off and restart the machine, if the problem
persist, the memory is damage.
CALL TECHNICAL SERVICE ASSISTANCE
ZERO CROSSING
ELECTRONIC DEVICE IS DAMAGED
Turn off and restart the machine, if the problem
persist, the memory is damage.
CALL TECHNICAL SERVICE ASSISTANCE
FILL
WATER FILL
Water fill not completed during the available
maximum time.
Verify the water supply is correctly connected,
opened and free of obstructions.
Verify the solenoid valve filter is free of
possible obstructions and deposit.
Verify the water supply pressure is adequate
(par.1D – Technical Data).
Verify the machine's door is completely closed
and the overflow device is correctly positioned
inside the tank.
)
messages are
restores default
DRAIN
DRAIN ANOMALY
Drainage not completed
available maximum time.
Verify the overflow device is completely
removed and not obstructions are present
on the water drain line.
BOILER PROBE
BOILER PROBE ANOMALY
Boiler temperature probe not connected or
faulty
CALL TECHNICAL
ASSISTANCE
TANK PROBE
TANK PROBE ANOMALY
Tank temperature probe not connected or
faulty.
CALL TECHNICAL
ASSISTANCE
RINSE PROBE
RINSE PROBE ANOMALY
Rinse temperature probe not connected or
faulty.
CALL TECHNICAL
ASSISTANCE
FOLLOWING ACTIONS
MACHINE ERROR OR BREAKDOWN:
Booster and tank heating elements are
interrupted, water load is disactivated,
control panel display visualizes the error
and the electronic card is inactivated. All
led buttons are OFF. Washing cycle is
interupted (stanby mode) and restored if
the problem is solved. It is always possible
to turn OFF the machine by pressing button
"A" ON/OFF, and if the problem is solved,
warning messages are not more displayed.
during the
SERVICE
SERVICE
SERVICE
AFTER
15