Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3D3 – FILTERS CLEANING
1- Turn OFF the machine by pressing button
"A" On/Off.
2- Manually remove the overflow and filters.
(Fig.25)
Fig.25
3- Wash and clean filters thoroughly with
fresh running water.
4- Reposition all filters and components
inside the machine.
3D4 – EXTERNAL SURFACES CLEANING
Before carrying out any cleaning operations,
turn off the power at the mains.
To reduce the emission of pollutants into
the
environment,
clean
appliance externally and where necessary
internally with products having a
biodegradability of over 90%.
WARNING!
CLEAN STAINLESS STEEL SURFACES BY
USING WARM SOAPY WATER; NEVER USE
DETERGENT
CONTAINING
SUBSTANCES
SCRAPERS, COMMON
OR
BRUSHES.
RINSE
USING A WET CLOTH AND
WIPE
DRY.
DO
APPLIANCE BY USING HIGH PRESSURE
WATER JETS.
3D5 – TURNING OFF THE MACHINE
1-
Completely drain the water from the tank.
(see par.3D1/2/3)
2-
Turn OFF the machine by pressing button
"A" On/Off.
3-
Close the door and turn off the power at
the mains.
the
ABRASIVE
NOR
STEEL
WIRE
WOOL,
THOROUGHLY
CAREFULLY
NOT WASH
THE
3E – WARNING MESSAGES
DISPLAYED ON THE CONTROL
PANEL
N.B.
If the machine is in the OFF mode,
warning messages will not be
visualized on the display. Turn ON the
machine to visualize the error type.
The
following
warning
visualized on the display:
ALR 1 - WATER FILL
Water fill not completed during the available
maximum time (10min).
Verify that the water supply is correctly
connected, open and free of obstructions.
Verify that solenoid valve filter is free
of obstructions and deposits.
Verify that water supply pressure is
adequate (par.1D – Technical Data).
Verify that machine's door is
completely closed and the overflow device
is correctly positioned inside the tank.
N.B.
If water fill timing expires or water
level signal is not responded to, the
solenoid valve is automatically
interrupted.
To
restart solenoid valve
press any button on the control panel.
ALR 2 - DRAIN ANOMALY
Drainage not completed on the
maximum programmed timing
Verify
that
the
overflow
completely removed and no obstructions
are present in the water drain line.
ACTIONS AFTER MACHINE ERROR :
Booster
and
tank
are interrupted, water load is deactivated,
control panel display visualizes the error
the electronic card is deactivated.
and
All LED buttons are OFF. Washing cycle
is interrupted (standby mode) and restored
if the problem is solved. It is always possible
to turn
OFF
the
machine
button "A"
ON/OFF,
is solved, the warning messages
problem
will no longer be displayed.
messages
are
.
device
is
heating
elements
by
pressing
and
if
the
14
Publicité
Chapitres
Table des Matières
