Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2D – DETERGENT AND RINSE AID
DISPENSERS AND SETTINGS
N.B.
This machine must be operated with an
automatic detergent feeder and, if
applicable, an automatic chemical
sanitizer feeder, including a visual means
to verify that detergents and sanitizers are
delivered or a visual or audible alarm to
signal if detergents and sanitizers are not
available for delivery to the respective
washing and sanitizing systems. Please
see instructions for electrical and
plumbing connections located in this
manual and in the feeder equipment
manual.
Before starting a new cycle the dispenser and
its pipe must be completely filled. Check the
level of the detergent or rinse aid and
eventually fill-up the tank.
N.B.
The level in the detergent or rinse aid tank
must not get empty or filled with corrosive
or inadequate products. The warranty does
not cover damages caused by improper
use
of
dispenser.
calibrated at manufacturer site: dispenser
settings after installation can be performed
only by qualified specialists.
1- Remove the front panel by unscrewing the
two screws located on the bottom. (Fig.6)
Fig.6
Before removing the front panel make sure
the machine is disconnected from the main
breaker.
2- Insert included dispenser tube inside the
detergent or rinse aid tank. (if available).
(Fig.7)
The
dispenser
is
Fig.7
2D1 –PERISTALTIC RINSE AID AND
DETERGENT DISPENSER
Setting of rinse aid dispenser is perfomed
acting on the screw accessible after
removal of front panel, under the tank door.
(see Fig.6)
1- Close gently all the way down the
dispenser by screwing anticlockwise
the needle valve of the dispenser.
2- Open up until reached necessary
quantity by screwing clockwise the
needle valve of the dispenser. (Fig.8)
Fig.8
Quantity for the first setting should be
according to the installator after evaluating
the hardness of the water and the type of
rinse aid used. Recommended rinse aid
standard
quantity
is
correspond to the maximum flow rate of the
dispenser.
Recommended
standard
quantity
is
correspond to the maximum flow rate of the
dispenser.
SUGGESTION
To check the effectivness of the rinse aid,
look at freshly washed glasses against the
light. Drops of water remaining on the glass
indicate an insufficient amount while
streaks indicate an excess. In case of light
coated presence that block dispenser
functions, remove the coat by soaking the
dishes for 30 minutes in a solution water
soap (1:10) before starting machine cycle.
0,16
gr/sec
that
detergent
0,77
gr/sec
that
9
Publicité
Chapitres
Table des Matières
