Uninstall (Long Period Of Inactivity) - MVP Jet-Tech 757E Instructions Pour L'installation, Emploi Et Entretien

2D2 – DISHWASHERS WITHOUT
DETERGENT DISPENSER
Manually add recommended
quantity from the supplier every 5 cycles.
Doses differ depending on water hardness and
soiled quantity that remain on the dishes.
N.B.
All dishwashers are ready to be installed
external dispenser or specific dispenser kit
through injector and relative tube or
through the hole with relative cap located
on the tank of the machine.
If changing to a different detergent or rinse
aid type (even one
manufacturer), you must rinse the suction
and pressure hoses with fresh water before
connecting the new detergent or rinse aid
container. Otherwise,
different types of detergent or rinse aid will
cause cristallisation, which may result in a
breakdown of the dosing pump. Failure to
observe this condition will invalidate the
guarantee and product liability.
WARNING!
DETERGENT SELECTION AND DOSAGE
ARE FUNDAMENTAL
GOOD RESULTS AND
MACHINE PERFORMANCES FOR LONG
TIME AND EXTENDED LIFE. FOLLOW
ALWAYS THE INSTRUCTIONS OF THE
MANUFACTURER
AGENTS. IMPROPER DOSAGES RESULT
IN UNSATISFACTORY WASHING RESULTS
AND REPRESENT SOURCES OF RIVERS
AND SEAS POLLUTION. DO NOT USE
CORROSIVE OR POLLUTANT PRODUCTS
TO PROTECT AND MAINTAIN MACHINE,
NEVER EXCEED DOSAGES INDICATED BY
DETERGENT MANUFACTURER. NEVER
LEAVE THE DISPENSER
CHARGED WITH
FOREIGN PRODUCTS
RESULT IN LOSS OF WARRANTY.
detergent
by the same
the mixing of
FOR WASHING
TO MANTAIN
OF CLEANNING
DRY OR
CORROSIVE OR
WHICH WILL
2E – MAINTENANCE
1- Descale the boiler, the internal surface
of the tank and the appliance water
piping once or twice a year.
2- Descale the rinse and wash jets every
month using vinegar or a descaling
agent.
3- The internal hose of the rinse aid and
detergent peristaltic dispenser should
undergo periodic maintenance (once or
twice a year).
4- Clean solenoid valve filter by extracting
it from the inside of the valve and by
unplugging the water inlet tube.
2F – UNINSTALL (Long period
of inactivity)
Machine can be taken out of operation
only by trained specialists authorized
for the purposes, who will provide for:
1- Shut water line off (water valve) and
electric supply (main breaker).
2- Completely drain the tank.
3- Remove and carefully clean the filters.
4- Completely drain the incorporated
dispenser hoses, removing them from
the containers.
5- Drain the detergent and rinse aid
nozzles with fresh water first and after
with water and glycerine (50% - 50%)
taking care that nozzles remain clean
and lubrified inside.
6- Drain completely
removing the screw located under the
machine.
7- Spread a thin film of vaseline oil over all
the stainless steel surfaces.
INSTALLATOR REMARKS
INSTALLATION DATE:________________________
INSTALLATION PLACE:_______________________
INSTALLATOR NAME:________________________
MACHINE SERIAL NUMBER:___________________
SIGNATURE:_______________________________
the booster by
10