General Reccommendations; Handling; Unpacking - MVP Jet-Tech 757E Instructions Pour L'installation, Emploi Et Entretien

1
ATTENTION
Carefully read this instructions booklet, as it
contains important advice for safe installation,
operation and maintenance. Keep this booklet
to hand in a safe place for future reference by
other operators.
Installation, use and service of the machine
can be performed only by qualified personnel,
especially trained to follow instructions:
WARNING!
• The
manufacturer cannot
responsible for injuries or damages of
any kind occurred to persons, machine or
others, due to lack of conformity with the
operation instructions indicated in this
documentation and for abuse, misuse
and lack of conformity
instructions indicated
documentation as well as installation,
uninstall, service, tune-up, maintenance
requiring the removal of the safety
barriers not performed BY TRAINED AND
AUTHORISED SPECIALISTS, will result in
the IMMEDIATE LOSS
WARRANTY.
• Loss of warranty will result also from any
service performed to the machine, when:
Safety barriers are removed without
disconnecting the power line and the
water supply. When any safety provision
of the machine has been bypassed,
removed or excluded.
• Machine is installed in provisional,
improper or unsafe conditions for lack of
compliance with safety provisions (fuses,
main breaker, ground line, or water inlet
and discharge valves).
• When unauthorized modifications or
additions of devices which modify the
operation cycles indicated on the data
chart delivered with the machine.
• When not genuine spare parts are used.
• Installation or storage in inadequate
spaces according to the indications of
manufacturer.
• Machine utilization different from the
scope foreseen as
documentation (ex. Dishes of type or
sizes different from specified).
• Utilization of dispensers with corrosive
products, not pure or dry.
- GENERAL RECOMMENDATIONS
be held
with the
in this
OF THE
written in the
1A – HANDLING
Use suitable means to move the appliance:
a lift truck or fork pallet trucks (the forks
should reach more than halfway beneath
the appliance).
1B – UNPACKING
Before opening the boxes, verify the
conditions and in case indicates damages
on delivery slip. After unpacking, check the
machine conditions, in case the machine is
damaged, communicate immediately to the
dealer.
Do not proceed with the installation if
damages are relevant to operate safely and
wait for qualified and authorized assistance
person. Save boxing components (plastic
bags, expanded polystyrene, nails, etc.)
outside the reach of children for safety
reasons.
1- Wear protective gloves to unpack the
appliance from the boxing. (Fig. 1)
Fig.1
2- Lift the appliance using a lift truck. (Fig.
2)
Fig.2
3- Remove the protection film of the
appliance. (Fig. 3)
Fig.3
4