Publicité
Les langues disponibles
Les langues disponibles
Product may vary slightly from what is illustrated.
1. Grill
† 2. Grease tray (Part # GP200-02)
† . Cooking surface (Part # GP200-01)
† 4. Regulator assembly (Part # GP200-0)
† 5. Match holder (Part # GP200-04)
Note: This appliance is designed for use with a self-contained LP-gas
or propane gas supply system.
PROPANE GAS NOT INCLUDED.
† . Carrying strap (Part # GP200-05)
† 7. Wire Electrode (Part # GP200-0)
† . Igniter (Part # GP200-07)
Note: † indicates consumer replaceable/
removable parts.
PREPARATION AND GRILL SET-UP
Before First Use
1. Remove grill from carton and discard all the packaging. Make sure there are no loose
parts.
Note: Before using your grill, read the instructions and your manual.
2. Remove and save literature.
3. Please go to www.prodprotect.com/applica to register your warranty.
Follow instructions for each step in the order they are listed as you look at the diagrams.
This will allow for easier assembly.
If you have any questions which require help, contact Customer Service and be sure to
mention the model number of your grill, which can be viewed on the underside of the grill
through the opening in the bottom of the bowl.
STEP 1. Place the grill on a flat table top or level surface where you will be using it. Make
sure the torsion bar is locked in the vertical position. If necessary, push the torsion bar
lock button and rotate the torsion bar upward; the lock button will lock back in place once
the torsion bar is fully engaged.
Before rotating
torsion bar
Fig. 1
STEP 2. Grasp the spring loaded pull handle of the right and left hand level adjusters at
the same time. Pull out and rotate away from you and toward the back of the grill. This will
unlock the lid. Continue rotating adjusters as you loosen the pull pressure and until the
pull handles lock into the bowl.
Pull level
adjusters
together
Fig.
STEP . Open the lid. Swing the right and left panel braces out and insert the hook into the
small slot at the front of the grill.
Open lid
Fig. 5
After rotating
torsion bar
Fig. 2
Rotate
counterclockwise
Fig. 4
Secure
panel
braces
Fig.
Publicité
