Publicité
Les langues disponibles
Les langues disponibles
User Manual
Viewing Modes
OSD – On screen display
In each of the viewing modes offered by the switch you will see the OSD appear
in the top left of the picture for each input whenever you make a change to the
video channel, viewing mode or audio channel. The OSD will stay on for a few
seconds and then disappear. In the example shown, CH1 is the video channel,
the ♪ icon denotes that the audio source is from CH1 and 1920x1080P is the
resolution of the input video signal.
Video Mode Selection
The various modes can be selected by cycling through using the push button on
the main unit or using the mode button of the IR remote control. The available
video modes are shown below. Cycling through these modes will also allow the
separate inputs to be designated as the main window within each mode.
Audio Mode Selection
Initially the audio channel in use will be the most recently used channel so for example if you switch from
input 1 directly to quad view mode then the audio from input 1 will be used, this is denoted by the ♪ icon
being displayed in the OSD of that input as shown above. Pressing the audio button on the switch or
remote control will switch the audio to the next input with each press and then after input 8 to audio off (no
♪ icon is displayed) before returning to input 1 with the next press e.g. 2 > 3 > 4 > 5 > 6 > 7 > 8 > 9 > Mute
> 1.
English
♪
CH1
1920x1080P
Publicité
