Publicité
Les langues disponibles
Les langues disponibles
User Manual
Product Diagram
Front Panel
▪
Power LED – This LED will illuminate once power has been provided to the switch.
▪
12VDC In – Connect the included power supply once connected to a mains power outlet.
▪
IR – IR receiver window for control using the included IR remote.
▪
RS-232 – Connect to a PC for control via the below RS-232 commands. Please use the control
software found at the local Lindy website – 38330 – Downloads.
▪
Audio – Switch between audio modes.
▪
Video – Switch between video modes.
Rear Panel
▪
HDMI IN9 – HDMI IN1: Connect up to 9 HDMI source devices using HDMI cables.
▪
HDMI Out: Connect to a single HDMI display using HDMI cable.
Side Panel
▪
Ethernet: Unused
Installation
1. Ensure all devices are powered off before connection. Once the power supply is connected the Power
LED will illuminate.
2. Connect any required HDMI input devices to the HDMIIN ports. Please consult the "Viewing Modes"
section of this manual to ensure source devices are being displayed in a desirable location.
3. Connect the display to the HDMI Out port using an HDMI cable.
4. Power on all devices.
5. For simple push button control use the Audio & Video switches on the front panel. The video switch
will allow for cycling through the various video modes listed below. The audio switch will allow for
cycling through the connected source device audio as described in the following pages.
6. For IR control, please ensure the IR receiver is in line of sight of the IR remote. For instructions on
the various functions of the IR remote please see the diagram below.
7. For RS-232 control, please connect a PC to the RS-232 port of the switch and open the control
software from the Lindy website. For instructions on RS-232 control please see below.
English
Publicité
