Nexgrill 720-0778B Manuel D'instructions page 40

Natural Gas Conversion for Model# 720-0778B
WARNING: IMPORTANT!
BEFORE LIGHTING...
Inspect the gas supply hose prior to turning the gas
"ON." If there is evidence of cuts, wear, or abrasion,
it must be replaced prior to use. Do not use the grill
if the odour of gas is present. Only the pressure
regulator and hose assembly supplied with the unit
should be used.
Never substitute regulators and hose assembly for
those supplied with the grill. If a replacement is
necessary, contact the manufacturer for proper
replacement. The replacement must be that
specified in the manual.
WARNING: Always keep your face and body as
far away from the burner as possible when
lighting.
TO LIGHT THE MAIN BURNER
Make sure all knobs are "OFF" then turn on the gas.
Always keep your face and body as far from the grill
as possible when lighting.
Your grill has an exclusive patented built-in ignition.
The igniter is built into the valve. To ignite each
burner simply push and turn the control knobs to the
HI setting, you will hear the valve click as it sends a
spark to the pilot flame. If the burner does not light
wait 5 minutes for any excess gas to dissipate and
then retry.
TO MATCH LIGHT THE SIDE BURNER
Hold a lit extended match near the side burner ports, turn
the control knob counterclockwise to
your hand immediately once the burner is lit. Rotate the
control knob to the desired setting.
Do not attempt to light the grill if
present. Call for service Canada: 800-648-5864,
U.S./Mexico: 800-913-8999
FLAME CHARACTERISTICS
Check for proper burner flame characteristics.
Burner flames should be blue and stable with no yellow
tips, excessive noise, or lifting. If any of these conditions
exist call our customer service line. If the flame is yellow,
it indicates insufficient air. If the flame is noisy and tends
to lift away from the burner, it indicates too much air.
Each burner is adjusted prior to shipment; however,
variations in the local gas supply may make minor
adjustments necessary.
TO LIGHT THE SEARING SIDE BURNER
To light the searing side burner, remove any cooking
utensils from the burner grate. Push and turn the control
knob counterclockwise to the "IGNITE/ON" position. If the
burner does not light, turn the control knob to
smell of gas is detected and the igniter is not functioning,
immediately turn the control knob
for any accumulated gas to dissipate. If the side burner
igniter is not functioning, see the following section for
match lighting.
TO MATCH LIGHT THE GRILL
If the burner will not light after several attempts then the
burner can be match lit.
Match light extension rod is located on the inside panel of
the door.
If you've just attempted to light the burner with the igniter,
allow 5 minutes for any accumulated gas to dissipate.
Keep your face and hands as far away from the grill as
possible.
Insert a lit match attached to the lighting rod through the
cooking grids to the burner.
Press the control knob and rotate left to the HI/ON setting
continue to press the knob until the burner ignites.
Burner should light immediately.
If the burner does not light in 4 seconds turn the knob off,
wait 5 minutes and try again.
"IGNITE/HI." Move
odour of gas is
Visually check the burner flames prior to each
use, the flames should look like this picture, if
they do not, refer to the burner maintenance
part of this manual.
"OFF." If the
"OFF." Allow 5 minutes
40