Nexgrill 720-0778B Manuel D'instructions page 18

12.Igniter Wire Installation
Insert the side burner ignition wire to the ignite module
as shown in Fig.19
Note: You only need to insert the side burner ignition
wire, the other five wires have been
Reminder: While completing
installation, make sure there is a
gap between the igniter pin and the side
burner, so that it ignites easily.
13. Battery Assembly
Unscrew the electronic igniter button and
place the battery (C1) into the housing
with positive terminal (+) facing outward.
Replace the ignition button after the
battery has been installed as shown in
Fig.20
14. Grease Tray, Greasy Box Assembly
14a) Use two 5/32-in.X10 mm
Head Screws (BB) and two 5/32-in flat
washers (HH) to fix the
tray (B1) and tank heat shield(D1) as
shown in Fig.21
14b) Place the side grease box (Z),
main grease tray (B1) with Tank
heat shield (D1) and Grease box
(A1) from the rear of grill as shown
in Fig.21
pre-assembled.
igniter wire
3 mm
Truss
main grease
Z
Assembly Instructions
Fig.19
SB igniter wire
Fig.20
Fig.21
C1
A1
2X 2X
BB HH
B1
D1
18