Dell PowerVault 35F Guide D'installation page 9

)LJXUH5HPRYLQJWKH5DFN'RRUV
3. Perform steps 1 and 2 to remove the back door from the rack.
Store the two doors where they will not injure someone if they accidentally fall over.
0RXQWLQJWKH%ULGJH2QWRWKH0DQLIROG
The manifold comes with attached inner-slide rails. The bridge is attached to these
inner-slide rails using the four 6-32 x 1/4-inch panhead screws.
To mount the bridge, perform the following steps:
1. Place the manifold on a clean, flat surface.
The word "top" is stamped on the manifold. Ensure that "top" is facing up.
2. Place the bridge behind the manifold and between the two inner-slide rails.
Ensure that the bridge is upright and the end with the power and cable
connectors is facing away from the manifold.
Dell PowerVault 35F Fibre Channel Bridge Rack Installation Guide
hinge
release
lever
1-5