Dell PowerVault 35F Guide D'installation page 5

'HOOŒ3RZHU9DXOWŒ)
)LEUH&KDQQHO%ULGJH
5DFN,QVWDOODWLRQ*XLGH
This document provides instructions for trained service technicians installing one or
more Dell PowerVault 35F Fibre Channel bridges in a Dell rack. The bridge rack-
mounting hardware includes:
‡
One manifold with an attached bezel and two inner-slide rails
‡
Two outer slides, each with a stationary and an adjustable bracket
‡
Four 6-32 x 1/4-inch panhead screws
‡
Eight 10-32 x 1/2-inch screws
‡
Eight tapered washers
The following sections describe the tasks required to mount the PowerVault 35F
bridge in a Dell rack.
%HIRUH<RX%HJLQ
Before you install your PowerVault 35F bridge in the rack, read the safety information
and tool requirement in the following subsections.
,PSRUWDQW6DIHW\,QIRUPDWLRQ
Follow these safety precautions when installing the PowerVault 35F bridge.
.LW,QVWDOODWLRQ5HVWULFWLRQV
:$51,1* 'HOOV\VWHPVDUHFHUWLILHGDVFRPSRQHQWVIRUXVHLQ'HOO VUDFN
FDELQHWXVLQJWKH'HOOFXVWRPHUUDFNNLW7KHLQVWDOODWLRQRI'HOOV\VWHPV
DQGUDFNNLWVLQDQ\RWKHUEUDQGRIUDFNFDELQHWKDVQRWEHHQDSSURYHGE\
DQ\VDIHW\DJHQFLHV,WLVWKHFXVWRPHU VUHVSRQVLELOLW\WRKDYHWKHILQDO
FRPELQDWLRQRI'HOOV\VWHPVDQGUDFNNLWVXVHGLQRWKHUEUDQGVRIUDFN
FDELQHWVHYDOXDWHGIRUVXLWDELOLW\E\DFHUWLILHGVDIHW\DJHQF\
Dell PowerVault 35F Fibre Channel Bridge Rack Installation Guide 1-1