Connecting Wires To Terminals - Kenwood KDC-1028 Mode D'emploi

Connecting Wires to Terminals

If no connections are made, do not let the wire come out from the tab.
When using the optional power amplifier,
connect to its power control terminal.
Depending on what antenna you are using,
connect either to the control terminal
of the motor antenna, or to the power
terminal for the booster amplifier of the
film-type antenna.
Connect to the terminal that is grounded
when either the telephone rings or during
conversation.
To front right speaker
Car fuse box
(Main fuse)
Front right output (Red)
(KDC-1028 only)
Front left output (White)
(KDC-1028 only)
Fuse (10A)
White/Black
To front left speaker
White
Gray/Black
Gray
Green/Black
To rear left speaker
Green
Purple/Black
To rear right speaker
Purple
Ignition key switch
–
+
Battery
Power control wire (Blue/White)
P.CONT
Motor antenna control wire (Blue)
ANT.
CONT
TEL mute wire (Brown)
MUTE
Car fuse box
ACC
Rear left output (White)
Rear right output (Red)
FM/AM antenna input
Wiring harness
(Accessory1)
FRONT • L
FRONT • R
REAR • L
REAR • R
Ignition wire (Red)
Battery wire (Yellow)
Ground wire (Black) - (To car chassis)
English
19
|