Connecting Wires To Terminals - Kenwood KDC-MP222 Mode D'emploi

Connecting Wires to Terminals

If no connections are made, do not let the wire come out from the tab.
Connect either to the power control terminal
when using the optional power amplifier, or to
the antenna control terminal in the vehicle.
Ignition key
switch
10
Car fuse box
(Main fuse)
11
+ –
Battery 12
2 KENWOOD disc changer control input
To connect the Disc changer,
consult your Disc changer
manual. 3
P. CONT
Power control/ Motor antenna
23
control wire (Blue/White)
Not Used
ANT CONT Motor antenna control wire (Blue).
9b
17
Do not let the wire
come out from the tab.
4b
ACC 13
Ignition wire (Red)
Battery wire (Yellow)
Car fuse
box 14
Ground wire (Black) · (To car chassis)
— 26 — — 26 —
Rear left output (White)
Fuse (10A)
24
Wiring harness
4a
(Accessory1)
25
29
White/Black
20
35
Green/Black
38
Purple/Black
20
21
22
26 Rear right output (Red) 27
REAR
L
FM/AM antenna input 1
R
To front left
speaker 30
White
31
32
Gray/Black
To front right
speaker 33
Gray
34
To rear left
speaker 36
Green
37
To rear right
speaker 39
Purple
40