Humminbird ICE HELIX Guide D'installation page 7

ICE HELIX® PORTABLE CONVERSION KIT Installation Guide
7
| Connecting Power
1. Connect the spade clip on the red wire of the power cable to the red (+) terminal on the
battery, and the spade clip on the black wire of the power cable to the black (-) terminal on the
battery. Make sure the spade clips are snugly attached to the terminals.
8
| Setting up Ice Fishing on the Control Head
Use the following instructions to get started using the control head for ice fishing.
See your control head operations manual for operations instructions.
1. Power On: Press the POWER key.
2. While the Title screen is shown on the display, press the MENU key. Select Normal mode, and
press the RIGHT Cursor key to start Normal mode.
3. Main Menu: Press the MENU key twice. Select the Sonar tab.
4. Select Ice Fishing Mode, and press the RIGHT cursor key to turn Ice Fishing mode On.
5. If the transducer is working properly, you will see the bottom on the sonar view.
Confirm the Connected Transducer: Depending on your control head model, you may have to
select the connected transducer in the menu system. To confirm the transducer, go to Main
Menu > Sonar > Connected Transducer.
Stowing the ICE Transducer
When you are done fishing, it is important to store the transducer and disconnect power.
1. Remove the transducer from the water, and wipe it dry.
2. Tuck the float under the control head.
3. Disconnect Power: Unplug the power cable when not in use.
CAUTION! Although the transducer cable is designed to be flexible in cold temperatures, you
must store your cable correctly to avoid stressing it. Make sure it is coiled smoothly, with
no kinks.
Specifications
Power Requirement ... ............ ...... ....................... .............. 12 Volt sealed lead acid battery up
to 16 hours continuous operation
7
532686-1_A