Warranty; Troubleshooting Guide - DeWalt DW718 Guide D'utilisation

RECONDITIONED PRODUCT: Reconditioned product is
covered under the 1 Year Free Service Warranty. The 90
Day Money Back Guarantee and the Three Year Limited
Warranty do not apply to reconditioned product.
FREE WARNING LABEL REPLACEMENT: If your
warning labels become illegible or are missing, call
1-800-4-D WALT for a free replacement.
E
Patent Notification
Manufactured under one or more of the following U.S.
patents:
6,823,765 6,101,914 5,907,987
6,810,780 6,035,754 5,862,734
6,520,059, 6,032,563 5,582,089
Other patents may be pending.
TROUBLE!
SAW WILL NOT START
SAW MAKES
UNSATISFACTORY CUTS
BLADE DOES NOT COME UP
5,375,495
TO SPEED
5,285,708
5,199,343
MACHINE VIBRATES
EXCESSIVELY
DOES NOT MAKE ACCURATE
MITER CUTS
MATERIAL PINCHES BLADE

Troubleshooting Guide

BE SURE TO FOLLOW SAFETY RULES AND INSTRUCTIONS
WHAT'S WRONG?
1. Saw not plugged in
2. Fuse blown or circuit breaker
tripped
3. Cord damaged
4. Brushes worn out
1. Dull blade
2. Blade mounted backwards
3. Gum or pitch on blade
4. Incorrect blade for work being done
1. Extension cord too light or too long
2. Low house current
1. Saw not mounted securely to stand
or work bench
2. Stand or bench on uneven floor
3. Damaged saw blade
1. Miter scale not adjusted correctly
2. Blade is not square to fence
3. Blade is not perpendicular to table
4. Workpiece moving
1. Cutting bowed material
15 15
WHAT TO DO
1. Plug in saw
2. Replace fuse or reset circuit breaker
3. Have cord replaced by authorized ser-
vice center
4. Have brushes replaced by authorized
service center or replace them yourself
as instructed on page 9.
1. Replace blade, see page 6.
2. Turn blade around, see page 6.
3. Remove blade and clean with turpen-
tine and coarse steel wool or house-
hold oven cleaner
4. Change the blade type, see pages 5.
1. Replace with adequate size cord, see
page 2.
2. Contact your electric company
1. Tighten all mounting hardware, see
page 6.
2. Reposition on flat level surface, see
page 6.
3. Replace blade, see page 7.
1. Check and adjust, see page 8.
2. Check and adjust, see page 8.
3. Check and adjust fence, see page 8.
4. Clamp workpiece securely to fence or
glue 120 grit sandpaper to fence with
rubber cement.
1. Position bowed material as shown on
page 13.