Cooke & Lewis CLAG60 Instructions page 5

Safety
Installation
All installation must be carried out by a competent person or qualified electrician. Before connecting the
mains supply ensure that the mains voltage corresponds to the voltage on the rating plate.
Direct connection
• The appliance must be connected directly to the mains using an omnipolar circuit breaker with a
minimum opening of 3 mm between the contacts.
• The installer must ensure that the correct electrical connection has been made and that it complies with
the wiring diagram.
• The cable must not be bent or compressed.
• Regularly check the power plug and power cord for damage. If the supply cord is damaged, it must be
replaced by a special cord or assembly available from the manufacturer or its service agent.
WARNING: This is a Class I appliance and MUST be earthed.
• This appliance should be connected directly to the mains power supply with a 3 Amp fuse protecting its
circuit.
• This appliance is supplied with a 3 core mains cable coloured as follows:
Brown = L or Live
Blue = N or Neutral
Green and Yellow = E or Earth
The fuse must be rated at 3 Amps.
To avoid the risks that are always present when you use an electrical appliance it is important that this
appliance is installed correctly and that you read the safety instructions carefully to avoid misuse and
hazards. Please keep this instruction booklet for future reference and pass it on to any future owners.
After unpacking the appliance please check that it is not damaged. If in doubt, do not use the appliance but
contact Customer Services.
The manufacturer declines all liability for damage caused to persons and objects due to incorrect or
improper installation of the appliance. Any permanent electrical installation must comply with the latest
wiring regulations applicable to your country and for your own safety a qualifi ed electrician or contractor
should undertake the electrical installation.
The appliance is supplied from the factory to use external ducting (not supplied). Should you wish to use
this in recirculation mode only, please fit the correct carbon fi lter (not supplied).
Technical data
Supply voltage
Power consumption - Fan
Power consumption - Luminary
Power consumption - Total
Protection class
Light bulb
ILCOSD Code
Information for EU No. 66/2014 and No. 65/2014
208862_s1_s2-5059340127538-C&L-A5-SM-Safety-V02.indd 4 208862_s1_s2-5059340127538-C&L-A5-SM-Safety-V02.indd 4
220-240 V~ 50 Hz
90 W
1 x 3 W Max
93 W
I
Max. 3 W
DSS-3-H-120 mm x 33 mm x 33 mm
04
19/10/2020 6:59 PM 19/10/2020 6:59 PM