List Of Parameters And Possible Modifications - Enofrigo MIAMI B&R Instructions Pour L'installation, L'utilisation Et L'entretien

3.3

List of parameters and possible modifications

Proceed as follows to set the configuration parameters:
– press the S key for 4 seconds
– the display reads out " PA "
– press the S key
– within 15 seconds, enter the parameter " PAS " (password) using the A and V keys. The default value is -19
– scroll through the parameters using the A and V keys until you reach the parameter you want to change
– press the S key
– within 15 seconds, press the A and V keys to set the value
– press the S key
– to exit the procedure, press the S key or wait for 60 seconds.
The following parameters are the most frequently used:
Parameter
SP
P2
Quantity displayed during functioning:
P5
- 2 = value of second analogue input
r0
d2 Evaporator temperature at end of defrosting
d7
Ambient temperature below which minimum temperature alarm
A1
Ambient temperature above which minimum temperature alarm
A4
A7
Evaporator temperature under or over which the evaporator fan is
F1
Description
Setpoint
Unit of measure of temperature:
- 0 = degrees Celsius (°C)
- 1 = degrees Fahrenheit (°F)
- 0 = ambient temperature
- 1 = operating setpoint
Operating setpoint differential
Duration of dripping time
is activated
is activated
Minimum temperature alarm delay
switched off
Default
Setpoint
4
Inputs
0
0
Defrosting
2
2
2
Alarms
0
40
15
Fans
-1
Range
min. max.
r1 (installer) r2 (installer)
0 1
0 2
0,1 15
-99 99
0 15
0 99
0 99
0 240
-99 99
37
EN
U.M.
°C/°F
- - -
- - -
°C/°F
°C/°F
min
°C/°F
°C/°F
min
°C/°F