Installation; Moving; Fitting The Handle - Enofrigo MIAMI B&R Instructions Pour L'installation, L'utilisation Et L'entretien

2.4

Installation

2.4.1

Moving

Once the appliance has been removed from its packing, proceed as follows to move it into position:
– Move the appliance near the place of installation
– only for models MIAMI MEDIUM, MIAMI MINI e MIAMI B&R: Pull out the drip tray (1) from the rear of the appliance, taking care
not to damage the cable (2)
– Steer the forks (3) of a pallet transporter under the appliance, lift it just clear of the floor and remove the pallet (4)
– Lower the appliance back on to the floor and replace the drip tray (1), taking care guide the cable (2) back into its original po-
sition.
a
WARNING!
While moving the appliance, take great care to prevent it falling over.
2 1
2.4.2

Fitting the handle

– Open the front door
– Position the handle (10) over the holes in the outside of the door
– Gently move away the seal (11) on the inside of the door to locate the holes. Fix the handle in place using the plastic spacers
(12) and screws (13)
– Return the seal (11) to its original position, taking care not to distort it
– Close the door then open and re-close the door to check that the handle is correctly secured.
10
3
12 11
4
13
12
13
13
12
13
10 12
2 1
33
EN
Fig. 8
Fig. 9