Operation; Preliminary Steps; Checks; Connecting To The Electricity Supply - Enofrigo MIAMI B&R Instructions Pour L'installation, L'utilisation Et L'entretien

3 OPERATION

3.1

Preliminary steps

3.1.1

Checks

Before switching the appliance on, perform the following checks:
– Check that the electrical power supply has been installed by a qualified electrician in conformity to applicable standards
– Check that the voltage of the appliance, as stated on the nameplate, corresponds to the voltage of the power socket
– Check that the power supply circuit has an efficient earth (ground) connection and a double pole switch with a residual current
circuit breaker
– Check that the power socket is of the right kind for the appliance's plug. Do not use extension cables or multi-socket adapters
EN
– Check that the power socket is easily accessible after installation
– Check that the place of installation conforms to all applicable technical and health standards.
d
STOP!
Do not put the appliance into service immediately. Wait
unpacking. If the appliance has been placed horizontally during transport, this time will be needed
for the refrigerant to settle inside the cooling system.
3.1.2

Connecting to the electricity supply

The appliance comes with the correct power plug for the country of destination.
Check that the power socket (1) is of the correct type for the appliance's plug (2), then push the plug into the socket.
f
WARNING! RISK OF ELECTROCUTION!
If the socket is NOT suitable for the appliance's plug, do not force the plug into the socket. Contact
your local dealer for further information.
d
STOP!
Do not use extension cables or multi-socket adapters.
34
AT LEAST TWO HOURS
2 1
from the time of
Fig. 10