Putting Into Service; Display Indications; Changing The Temperature Setpoint; Defrosting - Enofrigo MIAMI B&R Instructions Pour L'installation, L'utilisation Et L'entretien

3.2

Putting into service

Once you have completed the operations listed in the section
"Preliminary steps", the appliance can be put into service.
Proceed as follows:
– make sure that the appliance is connected to the mains as
described in "Connecting to the electricity supply"
– The display (1) lights up and shows the current temperature
inside the refrigerated cabinet
– The refrigeration system starts up and continues running
until the temperature inside the cabinet falls to the tempe-
rature setpoint.
NOTE: If the display reads out an error code (e.g. CSd), refer to
the "Alarm codes and resetting" section.
3.2.1

Display indications

Indications on the display inform the user of active procedu-
res (e.g. defrosting) or current settings.
The following table lists the possible indications that can ap-
pear on the display.
Led
B
G
H
Temperature is measured and displayed in
C
Temperature is measured and displayed in
F
If this LED is lit, the appliance is off (in
O
1
Fig. 11
Meaning
Compressor on
Defrost procedure running
Evaporator fan on
degrees Celsius
degrees Fahrenheit
stand-by mode)
3.2.2

Changing the temperature SETPOINT

To change the SETPOINT (default=4°C):
– press S
– the B LED starts to flash
– change the SETPOINT temperature using the A or V keys
– to exit the procedure, press the S key or wait for 15 se-
conds
– The B LED goes out.
If necessary, you can exit the procedure early by pressing the
O key. Changes to the SETPOINT will not be saved.
3.2.3

Defrosting

To begin manual defrosting, press the A key for 4 seconds.
depending on the default settings, defrosting cycles
NOTE:
may be performed automatically.
Proceed as follows to change the defrost interval:
– press the S key for 4 seconds
– the display reads out " PA "
– press the S key
– within 15 seconds, enter the parameter " PAS " (password)
using the A and V keys. The default value is -19
– scroll through the parameters using the A and V keys
until you get to parameter d0
– press the S key to display the setting
– set the value of the parameter (in hours) using the A and
V keys
– press the S key or wait for 15 seconds.
EN
Fig. 12
35