Settings; Functions - Festo SOEL-RTD-Q50-PP-S-7L Instructions De Service Et De Montage

SOEL-

Settings

The SOEL-RTD-Q50-PP-S-7 sensor can be configured as follows with functions 1 to 24 in setting mode (teach-in).
Button
Set button:
Toggle button: Select a function

Functions

No. LED Muster Description
1 Select Q
2 Set of current meas. value as 1
point of Q
3 Scanning zone: Set of current meas. value as
nd
2 switching point of Q
signal output (see function no 1).
4 N.C./N.O. change-over of switching func-
tions for Q
5 Q output mode.
2
6 Set of current meas. value as 1
point of Q
Q must be output (see function no 5)
2
7 Scanning zone: Set of current meas. value as
nd
2 switching point of Q
output (see function no 5).
8 N.C./N.O. change-over of switching func-
tions for Q
9 Pulse stretching of Q
10 Q output shows status "good target". Swit-
2
ching signal can be inverted with function
no 8.
* as long as the S button is pressed
28
Change / confirm a setting or set a switching point
output mode.
1
st
output.
1.
output. Q
1
.
1
st
signal output.
2
output. Q
2
.
2
and Q by 50 ms.
1 2
"ZA" status indicator
On = Q is a output
1
Off = Q is not a output
1
switching On* = Measured value valid
Off* = Measured value invalid
On = Measured value valid
must be Off = Measured value invalid
1
On = N.C.
Off = N.O.
On = Q is a output
2
Off = Q displays good target
2
switching On* = Measured value valid
Off *= Measured value invalid
On = Measured value valid
must be Off = Measured value invalid
2
On = N.C.
Off = N.O.
On = Pulse stretching on
Off = Pulse stretching off
On = Object within...
Off = Object outside...
...measuring range
Factory setting
On
Half measuring
range
Off
N.O.
Off
Good Target
Off
N.O.
Off
On
Festo SOEL-...0608b English