Chevrolet Performance LT1 Mode D'emploi page 6

Engine Oil Cooling
The engine as delivered comes with a liquid to liquid engine oil cooler. Engine oil is pumped thru the cooler and engine coolant
is pumped thru the cooler, to transfer the engine oil heat into the engine coolant. The engine coolant should route to the lower
portion of the radiator, or inlet hose of the coolant pump.
installation, the engine oil cooler can be used or it can be removed. If using this heat exchanger, then the following parts will
assist in the installation (Figure 4).
DESCRIPTION PART NUMBER
Hose-engine cooler
Fitting-block hose
Pipe-cooler outlet
Fig. 4
OUTLET PIPE
If the cooler is not used then the following parts can be used (Figure 5).
DESCRIPTION
Plug-block coolant
Plate-oil transfer
Bolt-oil plate
Fig. 5
BLOCK COOLANT PLUG
Performance Parts LT1 Engine
TITLE
ALL INFORMATION WITHIN ABOVE BORDER TO BE PRINTED EXACTLY AS SHOWN ON 8 1/2 x 11
WHITE 16 POUND BOND PAPER. PRINT ON BOTH SIDES, EXCLUDING TEMPLATES.
TO BE UNITIZED IN ACCORDANCE WITH GM SPECIFICATIONS.
QUANTITY
22768504 1
22876452 1
23479389 1
BLOCK FITTING
COOLANT HOSE
PART NUMBER QUANTITY
11611351 1
12630766 1
11562426 2
TRANSFER PLATE
Heat is then removed by the engine radiator. Depending on the
BOLTS
19328729
PART NO.
DATE
03JN14 Initial Release - Rocko Parker
13MY16 Revision - Rocko Parker
6
SHEET
REVISION
33
OF
AUTH
N/A
N/A