Basic Operation; Detaching The Front Panel; Attaching The Front Panel; Initial System Start-Up - Alpine CVA-1003 Mode D'emploi

Basic Operation

Detaching the Front Panel

1
Press and hold the PWR (Power) button for more
than 2 seconds to turn off the power.
2
Press the (Release) button at lower left side
until the front panel pops out.
3
Grasp the left side of the front panel and pull it out.
NOTES
• The front panel may become hot in normal usage
(especially the connector terminals), this is not a
malfunction.
• To protect the front panel, place it in the supplied
carrying case.

Attaching the Front Panel

1
First, insert the right side of the front panel into
the main unit. Align the groove on the front panel
with the projections on the main unit.
2
Push the left side of the front panel until it locks
firmly into the main unit.
2
NOTE
Before attaching the front panel, make sure that there is
no dirt or dust on the connector terminals and no foreign
object between the front panel and the main unit.
6
-EN
All manuals and user guides at all-guides.com
PWR
1 1
OPEN/CLOSE
• Compatibility with Factory Steering Wheel
Radio Controls
If your vehicle has steering wheel controls for
the radio, an optional steering wheel control
interface may be available to connect your
Alpine radio. For details, contact your Alpine
dealer.
• Controllable with Remote Control
This unit can be controlled with an optional Alpine
remote control. For details, consult your Alpine
dealer.
Point the optional remote control transmitter at
the remote control sensor.
Remote control
sensor
When the monitor
display is open.
• You can use the remote control even when the
monitor display is closed.

Initial System Start-Up

Immediately after installing or applying power to the
unit, it should be initialized. To do this, first, remove
the detachable front panel. Behind the front panel, to
the right of the connector, there is a small hole.
Using a pencil or other pointed object, press the
reset switch mounted behind this hole to complete
the initialization procedure.
RESET switch
Remote control
sensor
When the monitor
display is closed.