Setting Automatic Opening/Closing Of; Monitor; Turning Sound Guide Function On Or Off - Alpine CVA-1003 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Other Useful Features
Setting Automatic Opening/
Closing of Monitor
When the Automatic Opening/Closing mode is
"AUTO," the monitor automatically opens when
the ignition key is turned to the "ACC" or "ON"
position. The monitor automatically closes when
the ignition key is turned OFF.
After carrying out the steps 1 to 3 of "To display
the SETUP screen" described on page 31,
perform the operation show below.
1
When the monitor display is open, press and
hold the SETUP button for at least 2 seconds.
The SETUP screen appears.
2
Press the Preset 2 button to activate the
GENERAL setting mode. Press the Preset 2
button again to select AUTO OPEN.
3
Press the g DN or f UP button to set the
Auto Opening mode.
To set the Auto Opening mode OFF, press the
g DN or f UP button. If set to the "OFF"
position, the monitor should be manually opened
or closed by pressing the OPEN/CLOSE button.
To set another setting, press the Preset 2 button
or another Preset button.
4
After setting is completed, Press the SETUP
button to return to normal mode.
34
-EN
All manuals and user guides at all-guides.com
CLOCK
SETUP
TUNE
g
g
g DN
g
g
f UP
f
f
f
f
OPEN/CLOSE
Preset 2
Turning Sound Guide Function On
or Off
The Sound Guide function will give audible
feedback with a beep sound when a button on the
unit is pressed to acknowledge the receipt of the
signal from the button.
After carrying out the steps 1 to 3 of "To display
the SETUP screen" described on page 31,
perform the operation show below.
1
When the monitor display is open, press and
hold the SETUP button for at least 2 seconds.
The SETUP screen appears.
2
Press the Preset 2 button to activate the
GENERAL setting mode. Press the Preset 2
button again to select BEEP.
3
Press the g DN / f UP button to activate/
diactivate the Sound Guide mode. If you turn off
the Sound Guide mode, the sound guide beep
will not be produced when a button on the unit is
pressed.
To set another setting, press the Preset 2 button
or another Preset button.
4
After setting is completed, Press the SETUP
button to return to normal mode.

Publicité

Table des Matières
loading

Table des Matières