Switching Display Modes - Alpine CVA-1003 Mode D'emploi

Other Useful Features

Switching Display Modes

After carrying out the steps 1 to 3 of "To display
the SETUP screen" explained on page 31,
perform the operation described below.
1
Press and hold the FUNC button for at least 2
seconds in the AUX or NAV. mode.
Each press changes the display modes as
follows:
→ MODE 1 → MODE 2 → MODE 3 → MODE 4
(WIDE) (ZOOM) (CINEMA) (NORMAL)
MODE1
In the Mode 1 (Wide), the monitor displays a
normal picture wider to fit in the wide-screen
monitor by evenly stretching out the picture
horizontally.
MODE2
In the Mode 2 (Zoom), the monitor displays a
normal picture wider to fit in the wide-screen
monitor by unevenly stretching out. The center
portion of the picture is stretched out only slightly
in order to make the important center portion of
the picture look natural.
40
-EN
All manuals and user guides at all-guides.com
FUNC
MODE3
In the Mode 3 (Cinema), the monitor displays a
normal picture by stretching out the picture
horizontally and vertically. This mode is good for
displaying a cinema type picture with the
proportion of 16 to 9.
MODE4
In the Mode 4 (Normal), the monitor displays
normal picture at the center of the screen with a
vertical black belt at each side.