Publicité
Les langues disponibles
Les langues disponibles
1. INTRODUCTION
This manual should be carefully read and kept for as long as the grill plate is in use.
All operations such as installation, any kind of adaptations (e,i, changing the type of gas), or any kind of
repair, must be carried out by a qualified technician, who should carry out the regulations in force.
This device should only be used for the specific end for which it was built, It should never be subjected to
other combustible materials, abrasive detergents, or any other objects that might damage the plate.
Only adults should operate this device, and thus children should avoid touching the grill.
For hygienic and safety reasons, this device must always be kept clean.
These instructions are only valid for the countries mentioned on the ID plate.
2. INSTALLATION
When unpacking the machine, make sure that it is undamaged.
Remove all the materials used for packing as well as the plastic used to protect the structure of the machine.
Check the label on one side of the machine and make sure that the gas indicated is the same as the one that is
going to be used, If the machine is indicated for another type of gas, please remember that only a qualified
technician may carry out the change.
Choose the place where the machine is going to be installed, bearing in mind the following instructions:
-
The machine must be placed in a well ventilated location, underneath a suction fan with suction
capacity of at least 1500 m
-
The grill stand, as well as everything surrounding it must be made out of non-combustible materials;
-
There should be a distance of at least 150 mm between the grill and walls or any other machines;
-
The stand must be well leveled;
-
Make sure that the taps are turned off.
It is now possible to connect the gas hose (metallic tube), according to the regulations in force, avoiding all
kinds of pressure, any tight curves or squeezing the tube too much, The grill must be connected to a fixed
installation through a sphere type tap.
The equipment must be immobilized and fixed to the working surface. Use 4 M10-screws with at least 25
mm screw threat on the superior side. With the superior side, they lock into the equipment's feet. The
location of the screws on the working surface is defined by the edges of a rectangle with the following
dimensions:
3. USE
The grill plate has a plastic protection that must be taken off before using the machine, It is advisable to
clean the plate with a normal kitchen detergent and then grease the plate with a mixture of olive oil and
vinegar.
INSTRUCTIONS MANUAL (GB)
3
/h;
GGP6.4
GGP6.6
GGP6.8 / GGP6.4F
GGP6.10 / GGP6.6F
GGP6.8F
10
332 x 295 mm
532 x 295 mm
732 x 295 mm
932 x 295 mm
1132 x 295 mm
Publicité
