Samsung DVD-HR749 Manuel D'instructions page 97

Video
The disc revolves, but no image or bad quality
images is displayed.
Checkpoint 1 Be sure that the Video Setting is
properly set. (See pages 32~34)
Checkpoint 2 Check whether there is damage to or any
foreign material on your disc.
Some low quality discs may not play properly.
Checkpoint 3
Checkpoint 4 If scenes change from dark to bright
suddenly, the screen may shake
vertically temporarily, but this is not a fault.
Sound
No sound.
Checkpoint 1 Are you watching a programme in slow or skip
mode?
If you are playing a programme at a speed
other than normal speed, sound will not be
heard. (Except for forward search (X 2) in
disc.)
Checkpoint 2 Check the connections and settings. (See
pages 21~22, 30~31)
Checkpoint 3 Check whether the disc is damaged. Clean
the disc, if necessary.
Checkpoint 4 Check whether the disc is inserted
correctly with the label facing up.
No audio output.
Checkpoint 1 Check whether you have selected the correct
digital output options in the Audio Output
Options menu.
(See pages 30~31)
Timer Recording
Timer lamp fl ickers.
Checkpoint 1 Check there is enough space in the disc or
HDD for recording.
Checkpoint 2 Check whether the current disc is recordable
or not.
Make sure to check before the start time of
recording.
Timer recording does not work properly.
Checkpoint 1 Re-check the recording time and the end time
settings again.
Checkpoint 2 Recording will be cancelled if the power is
interrupted due to a power failure or another
similar reason while recording.
Remote Control Unit
The remote control doesn't work.
Point the remote control at the remote control
Checkpoint 1
sensor on your HDD & DVD RECORDER.
Allow for proper distance. Remove obstacles
between your HDD & DVD RECORDER and
the remote control.
Checkpoint 2 Check whether the batteries are drained.
Checkpoint 3 Check the TV/DVD selection button setting.
Checkpoint 4 Check whether TV control button is selected
or not.
Other
I forgot my password for parental supervision.
Checkpoint 1 Press and hold the PROG (
the front panel of the Recorder for more than
5 seconds with no disc in the unit. All settings
including the password will revert to the
factory settings. Do not use this unless
absolutely necessary.
(Note that this function is possible only when
no disc is inserted.)
Is it possible to change a subtitle and an audio
signal on a recorded disc?
Checkpoint 1 A recorded disc is played with only the subtitle
and the audio signal which were selected
during recording.
Other problems.
Read the table of contents and then fi nd and
Checkpoint 1
read the section describing your problem,
follow the instructions given.
Plug your HDD &DVD RECORDER off and
Checkpoint 2
on.
If the problem still persists, contact a nearby
Checkpoint 3
Samsung service centre.
English - 97
) buttons on