shark Explore-R Mode D'emploi page 6

ChINSTRAP - PRECISE lOCk buCklE
A
D
holding system
Depending on the various versions and the
country concerned, your Explore-R SHARK
helmet is equipped with a chin strap with a "Pre-
cise Lock" rapid buckle with a snap lock or one
with a double D ring.
The "Precise Lock" snap lock system gives you
precise and accurate adjustment because of the
considerable length of its notched section.
However, it is essential on purchase to adapt
the length of the chin strap to your measure-
ments. Adjust the length of the strap using the
adjusting buckle (Figs. A, B, C and D). Choose
your Explore-R helmet and attach the holding
system. When the "Precise Lock" is adjusted
to the medium position, the chin strap must be
correctly tensioned under the chin to hold the
8
B
E
helmet firmly without causing you any discomfort
or pain.
To fasten the chin strap, all you have to do is to
thread the tongue into its place on the buckle un-
til tension is perfect (Fig. E). The tongue connects
and is automatically blocked.
To release the chin strap, you have to pull on
the lever (Fig. F) and remove the tongue from the
buckle. Although the notched tongue enables you
to change the adjustment precisely on each use,
it is important to check frequently that the adjust-
ment of the strap length is correct.
Warning: never ride with the chin strap loose or
insufficiently tightened. Even though the interior
padding gives you the impression of being held,
your helmet risks coming off in a fall. Never apply
lubricating or acid products or grease or solvents
to the chin strap buckle parts.
C
F