Textile Parts - shark Explore-R Mode D'emploi

ThE TExTIlE PARTS
The textile and foam parts providing comfort
to the Explore-R make it easy for you to ap-
preciate the performance of your helmet to
the full.
The parts in contact with the skin are made
in a fabric that is guaranteed to feel pleasant,
to absorb perspiration well and to resist wear
satisfactorily. We treat surfaces to limit the
risk of mould and bacteria.
WARNING: although they are selected for their
quality of resistance and satisfactory wear,
E
Remove the support piece from the neck
support by pulling the front (wind protection
all the interior padding is subject to normal
wear depending on use and care and mainte-
nance, the length of use and also the degree
of acidity of your perspiration. If you note any
wear, we advise you to replace the interior
padding in order to keep your helmet perfec-
tly clean and comfortable. Your SHARK sup-
plier can propose you with replacement parts
and also offer you cheek pads of different
thicknesses and densities, should the stan-
dard selection not correspond to the contours
of your face.
NECk SuPPORT
F
mask) toward the outside, do the same opera-
tion for the rear (see photo E, F, G)
TExTIlE PARTS - REmOVAl
G
15